Line up the pre-drilled screw holes on tops of aluminum frame with the holes on top of Top frame and tighten in place with an M5x25 screw and washer at each corner. Place the Top frame on top of all four aluminum frames. Make sure the front of the bottom frame is facing you. Facing your top-side Y-axis passive block, you can adjust it to adjust the timing belt tightness. Tighten the four screws on the top, then tight the side screws. Install the remaining 2 aluminum profile in the same way as Step 3. Use 2 M5x25 screws and washers to secure part to the bottom frame. Notice the hole at the top of piece facing left and right, in relation to the front of the printer. Take one of the Aluminum frame pieces and place it in the corner of the bottom frame, on top of the frame, and lined up with the corner. Keep the front of the Bottom Frame facing you. 
Note: Please note that the hole at the top of piece facing left and right, in relation to the front of the printer.
Children under 10 years of age should not use the printer without supervision. Use glass cleaner or isopropyl alcohol to clean the print surface before every print for consistent results. Always turn the power off when cleaning, and wipe with a dry cloth to remove dust, adhered printing plastics or any other material off the frame, guide rails, or wheels. When cleaning debris from the printer hot end, please use the provided tools. Such cloths may become tangled in the printers moving parts leading to printer damage, burns, or personal injuries. 
Do not wear gloves or loose clothing when operating the printer. Keep hands away from machine while in use to avoid burns or other personal injuries. 
Do not touch the nozzle or printing surface during operation as they may be hot.For your safety, you must use a grounded three-prong power outlet. Do not use any other power cable except the one supplied.Before using experimental or exotic filaments, we suggest using standard filaments such as ABS or PLA to calibrate and test the machine.Please place your printer under a stable environment in order to achieve hight print quality.We suggest placing it in a well-ventilated, low-dust environment. Do not place the printer near any heat source or flammable or explosive objects.Do not use the printer any way other than described herein in order to avoid personal injury or property damage.
Detailed instructions are available in the TF card. Please plug the power cord into a three-hole power jack. This guide book is for standard Ender-5 Plus only.
0 kommentar(er)
